www.tomyang.net

Thank you -i did see kerry's site info -

let me check maser nut guy out.

Looking for 3 or more of these badges - with the real metal frame holders and threaded Studs.

Not concerned about condition as ill rechrome them - but need to be metal with threaded studs pls

size is 20MM x 144MM

Usually these are about 50.00 apiece.....

Thank you in advance

Example below:

Need to find a new MR jack top cover piece - mine is corroded badly and a newer one would look so much better

here is a sample of what i need

the top piece with the MR casted into it

I have an old jack assembly that i pulled off the shelf today - tried it and the shaft does not move. Taking it apart - i have discovered the gears inside that drive the shaft are gone. 4082723B-189E-445B-96BA-F42671F8D4D7.jpeg Where do you get replacement gears for this jack......otherwise pretty c...

pic would help if you can supply one pls

kevin, call me - I've been down this route - 480-208-8259

ed montini

Pic would help if you have one - thank you

next time im at GT car parts i can look.....

the issue bill is having is his shipping guy up and left so he is the shipping dept as well - he is so backed up -

anyhow let me know, i try to get up there every other week....

PM sent to u

Also - i have a collection of these old and new style - i have found variations of the length by 1 MM. Good practice to clean the fues block ends, slightly bend them and insert fuse and CHECK the fit....slightly loose causes you chasing your tail all over the place trying to fix a problem. Related t...

yes that is my concern for sure -

i had some oil leaks that we have been chasing on the 250 engine, inside plug motor - currently we have 2 small ones left to fix!!! one leak i have is at the timing chain tension sprocket to the block gasket. To fix this i need to remove the 4 nuts that hold the sprocket housing to the block. Questi...

looks similar to the GTC .........

tough find - i wold cut one out of brass and have it plated would be the quickest and easiest method.

Do you have the capability to do this?

do u have a picture of what your looking for?

sold 2

have 2 left!!

Sorry correction - 75.00 per 10 ft section.........