These guys are GREAT
for those hard-to-find Metric Fasteners
e.g. they had the 18x1.5x120mm Bolt I needed
http://www.metricmcc.com
site is pretty well executed, too
(once you figger it out; e-price is easier to use than catalog)
Metric Fasteners
Tom, these guys even have metric square nuts.
See http://www.metricmcc.com/queryFrame.asp?C=6&DefID=80
See http://www.metricmcc.com/queryFrame.asp?C=6&DefID=80
Regards, Kerry
http://www.330gt.com 330 GT Registry
http://www.parrotbyte.com/kbc/ferrari 250 PF Coupe 1643GT, 330 GT 2+2 8755GT, 308 GTS 23605
http://www.330gt.com 330 GT Registry
http://www.parrotbyte.com/kbc/ferrari 250 PF Coupe 1643GT, 330 GT 2+2 8755GT, 308 GTS 23605
minimum
please be aware, as wholesale distributors
these guys have (pretty severe at times) minimums
e.g. 6mm 'Tall' Nyloc Nuts @100 pcs
however, @ $0.079 each, it doesn't seem too bad
especially compared to the $4.00+ EACH
I was quoted 'from Ferrari'
in my case as I am re-painting the engine
and want to use new fasteners
I will be using quite a few-
besides, in the case of the 6mm Locknut
it seems that about a gazillion of these are used on my car
(10 mm wrench size)
so having some spares around is a good thing
these guys have (pretty severe at times) minimums
e.g. 6mm 'Tall' Nyloc Nuts @100 pcs
however, @ $0.079 each, it doesn't seem too bad
especially compared to the $4.00+ EACH
I was quoted 'from Ferrari'
in my case as I am re-painting the engine
and want to use new fasteners
I will be using quite a few-
besides, in the case of the 6mm Locknut
it seems that about a gazillion of these are used on my car
(10 mm wrench size)
so having some spares around is a good thing
AKB
~~~~~~~
400i SI 32635
~~~~~~~
400i SI 32635
I have noticed that ACE Hardware carries a wide selection of the common metric nuts and bolts. For high strength engine bolts always check the stamp on the bolt head 8.8 to 10.9 etc., and obtain them from a knowledgable source. Ferrari dealers carry a good but expensive selection if you need only one or two.