A different 330 tools question

Moderators: 330GT, abrent

Post Reply
Michael Bayer
Posts: 699
Joined: Mon Nov 04, 2002 7:22 am

A different 330 tools question

Post by Michael Bayer »

Can someone with a proper toll kit provide the dimensions of the pliars and the machinists hamer in the factory kit? Michael
Mike Adams
Posts: 9
Joined: Wed Sep 04, 2002 5:29 am
Location: Laguna Beach, CA & Las Vegas, NV
Contact:

Post by Mike Adams »

I remember the pliers being 180mm in my 330GT 2+2 kit. Same as my Daytona kit. The look ALLOT like these USAG pliers with the rubber handles pulled off.

http://64.66.16.224/pliers-usag.jpg

Here is a pic of the 365GTC toolkit from the carrbooks handbook. ( "The green book" )

http://64.66.16.224/365-tools.jpg

They look the same as my 330 pliers.


I will have to measure the 500g hammer when I get back to Las Vegas. next week.
Michael Bayer
Posts: 699
Joined: Mon Nov 04, 2002 7:22 am

Post by Michael Bayer »

Thanks much, the measurements of both would be appreciated! Michael
User avatar
330GT
Posts: 1640
Joined: Wed Sep 04, 2002 9:30 am
Location: Seattle, WA
Contact:

Post by 330GT »

The pliers are approximately 7 3/4" long. Here's a picture of an original pair:

Image

For more pictures of both original and reproduction tools, see:
http://www.parrotbyte.com/330GTRegistry/
Click on Resources and then Toolkit Information.
Michael Bayer
Posts: 699
Joined: Mon Nov 04, 2002 7:22 am

Post by Michael Bayer »

Thanks! Michael
Post Reply