Posted by Todd
A while back there was a discussion of knock-offs and tools for them. Since then I bought a tool made by Mike Kumor at Seaport Mold & Casting. It is basically a round tube with notches cast in it to fit over the ears of the knock-offs. The business end is coated with rubbery stuff to prevent damage to the knock-offs. He makes these at his foundry, so I am sure he would be willing to sell as many of them as those of you out there might want.
Knock-offs & Tools
Re: Knock-offs & Tools
Posted by yale
can we see a picture? do you then use a pipe for torque? Yale
can we see a picture? do you then use a pipe for torque? Yale
Re: Knock-offs & Tools
Posted by Mike Adams
I use Mike Kumor's knockoff tool also. It is a big help at not over/under tightening the spinners. Just set the torquewrench to 350ftlbs. Here is a pic.
It leaves no marks on my spinners.
I use Mike Kumor's knockoff tool also. It is a big help at not over/under tightening the spinners. Just set the torquewrench to 350ftlbs. Here is a pic.
It leaves no marks on my spinners.
Re: Knock-offs & Tools
Posted by Mike Adams
Oops... I thought it would just post the link, not the whole image... Anyway, it uses a 3/4 torquewrench.
Here is a link to the site.
Now... to get him to make me some 6X DCN manifolds for my 330
Seaport Molding and Casting.
Oops... I thought it would just post the link, not the whole image... Anyway, it uses a 3/4 torquewrench.
Here is a link to the site.
Now... to get him to make me some 6X DCN manifolds for my 330
Seaport Molding and Casting.