Hello guys,
I just had the problem of a rotten original heater valve. The attachment tubes already were recreated with jb-weld, but were very fragile and one broke away. I think, it finaly is beyond repair. Original replacement is not available, just the generic cheap heater valve, wich is entirely wrong.
So I took the route of 3d printing and had a friend help me, making a cad file. I printed in regular plastic to check and ordered a aluminium printed part, when I was happy.
I also have the file for the top half of the valve.
So far, it was an expensive exercise, but I am pretty happy with the outcome. I know, the finish is a bit different, than the original part, but assume it will dull over time with use and heat cycles.
If someone also need replacement, I happily help.
3d printed aluminium heater valve housing
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
Re: 3d printed aluminium heater valve housing
Great work. I think there will be some interest in this part. I'll make blog post about it soon to help get the word out.
I think I've seen the top plate being remanufactured, and it would be interesting to see if it fits.
Thanks for making the effort.
Tom
I think I've seen the top plate being remanufactured, and it would be interesting to see if it fits.
Thanks for making the effort.
Tom
'63 330 America #5053
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
Re: 3d printed aluminium heater valve housing
Hi Tom,
I know, GTC Parts makes also a top housing of the valve, but it is a bit different.
https://gtcp.com/portfolio/reproduction ... valve-top/
They have done a great job, but their part is for the later valve, as in GTCs and Alfas with three hose pipe valves.
Thank you very much for your comment.
I know, GTC Parts makes also a top housing of the valve, but it is a bit different.
https://gtcp.com/portfolio/reproduction ... valve-top/
They have done a great job, but their part is for the later valve, as in GTCs and Alfas with three hose pipe valves.
Thank you very much for your comment.
-
- Posts: 75
- Joined: Tue Dec 18, 2012 8:18 am
Re: 3d printed aluminium heater valve housing
I just want to say, it is working perfectly. Had the car out for 3 rides so far and it is not leaking and opening and closing perfectly.
The heater is very good, so you can drive open top in cold weather.
The heater is very good, so you can drive open top in cold weather.